Liquid Gel Transport image

Click on + for more info.

EQUIPMENT DESCRIPTION

5,000 gallon, two (2) compartment MC412MS tank trailer. Compartment sizes of choice.

Two (2) hydraulically mixing paddle assemblies will be installed above the compartment outlets. One (1) per compartment. Blind flanges will be provided to install in place of each hydraulic motor for acid service use.

Product – Various gel and acid fluids

Suspension – Heavy duty air ride suspension assembly

Axles – 2-D22 22,500lbs axles Dana with spring brakes and outboard drums

Brakes – 16- ½” X 7” X ¾” and Sealco 4S/2M ABS Air System

Tires and Wheels – 11R 24.5 radial tires on aluminum wheels

Landing gear – 2 speed roll-up 50K lift, 140K static load.

Lights – 12 volt LED work lights powered off the customer supplied tractor for night time operations. Work light will illuminate all work areas and ladders.

Domes – 2-18” Clay and Bailey with drip pan and drain hoses.

Overturn Rails – Overturn protection, Tombstone type for each compartment

Ladder/Walkway – Ladder at center drivers side to walkway with handrails. Meets OSHA standards.

HYDRAULIC SYSTEM

The customer supplied wet kit mounted on the tractor will power the hydraulic system. This system will have on the operator control panel flow control/RPM speed increasers or the following – one (1) centrifugal pump and two (2) mixing paddles.

PLUMBING

The unit will have the ability to take suction from the driver’s side of the unit and from two (2) inlets located at the rear of the unit via 4” manually operated butterfly valve.

Two (2) 4” air open/spring closed butterfly valves located underneath each compartment, two (2) 2” load lines will be located topside of the unit, one (1) per compartment, and 2” piping will run along the exterior of the tank on the passenger side.

Each compartment will have internal removable jets angled at a 35 degree angle to provide additional mixing. The unit will have a 2” discharge connection at the rear of the unit.

CENTRIFUGAL PUMP

A hydraulically operated centrifugal pump will be installed to load tanks, recirculation, or boost downstream.

CONTROL AND MONITORING

Installed at the rear of the unit will be a control console with all necessary controls and gauges for the full and complete operation of this unit during all possible phases:

Hydraulic Controls

  • One (1) centrifugal pump speed controller, two (2) mixing paddle speed controllers

Miscellaneous

  • Work light switches
  • Butterfly switches will be open/closed style

OTHER SPECS

One (1) 2” X 75’ transfer hose with hammer union connections

One (1) manual hose reel assembly to store 2” X 75’ transfer hose

One (1) hose trough, and flip placards.

COATING

Internally line with TNEMEC Epoxy coating